Waldorf MicroWave XT Bedienungsanleitung PDF herunterladen (Seite 99)

6. Briefly press the Utility key 햷 while holding the Shift key 햽 again.

See appendix for detailed information on system exclusive specifications.

 Depending on the selected type, the dump may take some time. The MicroWave

II/XT/XTk cannot be played during this time.

Receiving System Exclusive Data

You are not required to activate a special receive mode at the MicroWave in order to

receive system exclusive data via MIDI. The transmission is activated via a Dump Request

command originating at the device that is sending the messages. However there are a few

things you should check prior to the transmission:

• Check out the parameter Device ID. Data transmission will only be executed

successfully if the sender and receiver setting coincide.

• Make sure none of the MicroWave II/XT/XTk’s programs are in Edit mode. All edit

buffers are cleared via data transmission and therefore all edits that were not stored

prior to the dump will be irretrievably lost!

After activating the dump command at the sender device, the MicroWave II/XT/XTk will

receive data and store these in its memory.

 When the MicroWave II/XT/XTk receives a Sysex dump with the device ID

127

, it

will always accept the dump, regardless of the setting of its Device ID parameter.

Device ID

127

is a so-called "Broadcast ID" that addresses all connected MicroWave

II/XT/XTks. The MicroWave II/XT/XTk can receive this from other devices, but it

cannot send a Broadcast ID to other devices. This function is limited to special

computer software.

Also a checksum of

127

is always accepted as valid.

User’s Manual MicroWave II • MicroWave XT • XTk

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 125 126

Keine Kommentare

Waldorf MicroWave XT Bedienungsanleitung Seite 99