Waldorf 2-Pole Bedienungsanleitung PDF herunterladen (Seite 22)

Basic Operation

2-pole Analog Filter User´s Manual 22

Basic Operation

Powering On / Off

The 2-pole Filter is equipped with a Power switch 2.

Push it to switch on the unit. After that, the 2-pole Filter is

ready for some action. Push the Power switch again to

switch off the 2-pole Filter.

Where are the Presets?

The 2-pole Filter is a pure analog device. Because of the

very clear controls, we can assure you that you will be

able to set an universe of settings within a short time.

Editing

In spite of the 2-pole Filter’s compactness, it uses a sophi-

sticated user interface allowing fast editing of any parame-

ter.

Turning a dial clockwise increases the corresponding

value; turning it counterclockwise decreases it. Unbe-

lievable! Keep in mind that some switches offers more

than two states.

Envelope Input

This input drive the envelope follower unit. It is suitable

for a regular synthesizer control voltage (supported volta-

ge range: 0 V – 5 V), a foot-pedal (best impedance range:

10 k – 47 k) or a line level audio signal (audio interface,

drum computer output etc.). The incoming signal is added

to the envelope follower input. If you want the envelope

following the input signal only, the trigger unit has to be

disabled. Read more about triggering in the chapter "Enve-

lope Section".

Cutoff CV Input

The Cutoff frequency can be modulated by an external

control voltage, e.g. from a Waldorf Pulse 2 or a modular

synthesizer. You can also use an expression pedal or an

audio signal (e.g. a rhythmic signal).

Gate Input

The Gate input can be used to trigger the envelope by an

external signal, e.g. from a modular synthesizer.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Keine Kommentare

Waldorf 2-Pole Bedienungsanleitung Seite 22